Sb-filters Cold Air Intake Scoop AS-1007 Manuel d'utilisateur télécharger pdf

WARNING!

(MUST READ PRIOR TO INSTALLATION)

II. Scoop Obstruction:

Regularly inspect the entire Scoop Inlet for any obstruction or debris that may impede the flow of air.

III. Decreased Ride Height

Once the Scoop has been installed, please be aware that the Scoop sits lower than the bumper and drive accordingly

to avoid damage to the scoop or vehicle. Make sure there is plenty space between your tire and the scoop before

driving. The scoop system may not work with aftermarket wheels and tires.

IV. Do NOT Seal Off Stock Inlet Location:

In addition to pulling air from the base of the air box, the S&B Cold Air Intake Kit pulls air from the same location as

the stock induction system. UNDER NO CIRCUMSTANCE SHOULD YOU SEAL OFF THIS AIR INLET. Doing so

could result in severe injury or death or damage to the vehicle or property. Sealing off the stock air inlet could cause a

significant vacuum should the Scoop become partially or completely obstructed which among other things could pull oil

into intake tube leading to an explosion and/or a run-away truck condition as the oil would serve as fuel to the engine.

15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 - www.sbﬁlters.com 1

V. Warranty for Scoop & Filter Wrap

S&B provides a limited warranty to guarantee the product is free of material and workmanship defects. Any product will be

replaced upon identification of such defect. Normal wear and tear is not covered under this warranty. Final authorization is at the sole

discretion of S&B Filters, Inc.

VI. How long will the Scoop & Filter Wraps Repel Water?

The Scoop & Filter Wraps are specially treated to repel water. The water repellency longevity is dependent upon driving conditions

and the number of times the filter is cleaned. Generally speaking, we recommend changing the Filter Wrap every 6-12 months.

However, a quick test can determine if it is time to change your Filter Wrap. Simply take an ordinary clean spray bottle filled with water

and gently spray the Filter Wrap. If the water beads off the Filter Wrap, your water repellency is still working. If you see water enter

through the Filter Wrap, it is time to purchase a new Filter Wrap.

I. Water Ingestion Disclaimer:

This product is intended for general highway use only! Under normal driving conditions water ingestion is usually not

an issue; however, if the product becomes submerged from rain splashes or mud puddles due to harsh rains or

flooding the engine may ingest water which could cause severe engine damage. Do NOT use this product when

crossing any body of water including but not limited to large puddles, streams, rivers or lakes. S&B has conducted

extensive water testing with Southwest Laboratories to design a product, which was engineered to

protect your vehicle. The testing was done at 381 CFM and according to the SAE J2554, Engine intake Air

Water Separation Test Procedure that has been attached and can also be found on our website.

If your engine ingests water, this could cause severe engine damage by hydro-lock or other conditions. Care should be

taken to avoid these driving conditions. ENGINE DAMAGE CAUSED BY THE INGESTION OF WATER INTO THE

ENGINE IS THE DRIVER’S RESPONSIBILITY AND IS NOT COVERED BY S&B FILTERS!

The table below demonstrates what percentage of the water bypassed the filter during the SAE J2554 Test Procedure.

Standard Scoop Configuration With:

Water Bypassing the Filter, %

Cotton Filter (KF-1035)

0.097

Visit www.sbfilters.com to see the entire Test Report and learn more about this product.

1 2 3 4 5

Résumé du contenu

Page 1 - WARNING!

WARNING!(MUST READ PRIOR TO INSTALLATION)II. Scoop Obstruction:Regularly inspect the entire Scoop Inlet for any obstruction or debris that may impede

Page 2 - P/N: AS-1007

1. Note: Turn the front wheels to the left before starting to gain extra clearance. With the ignition switched off and the parking brake set, disconn

Page 3

15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 - www.sbﬁlters.comINSTALLATION INSTRUCTIONS (continued)P/N: AS-100

Page 4 - REMINDER!

15461 Slover Ave., Fontana, CA 92337 - Phone: (909) 947-0015 - Fax: (909) 947-0603 - www.sbﬁlters.comINSTALLATION INSTRUCTIONS (continued)P/N: AS-100

Page 5 - EXPLODED VIEW

ITEMQTY.DESCRIPTIONP/NA3Washer, S.S. SealingAI1272-00B3Hex Head Screw, #10-32x1.0”AI1490-00C1Scoop ChannelAL1144-00D1Scoop BaseAL1145-00E3Clip Nut, Se

Commentaires sur ces manuels

Pas de commentaire

Sb-filters Cold Air Intake Scoop AS-1007 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires d'air Sb-filters Cold Air Intake Scoop AS-1007. S&amp;B Filters Cold Air Intake Scoop AS-1007 User Manual [it] Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires d'air Sb-filters Cold Air Intake Scoop AS-1007

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires d'air Sb-filters Cold Air Intake Scoop AS-1007. S&B Filters Cold Air Intake Scoop AS-1007 User Manual [it] Manuel d'utilisatio